Kia Cee'd: Charging System / Alternator Specifications

Kia Cee'd JD Service Manual / Engine Electrical System / Charging System / Alternator Specifications

Specification

Alternator [Non-ISG type]

Item		Specification
Rated voltage		13.5V, 90A
Speed in use		1,000 ~ 18,000 rpm
Voltage regulator		IC Regulator built-in type
Regulator Setting Voltage	External mode	Refer to below graph
	Internal mode	14.55 ± 0.3V
Temperature Gradient	External mode	0 ± 3 mV / °C
	Internal mode	-3.5 ± 2mV / °C

※ Regulator Setting Voltage (External mode)

Alternator [ISG type]

Item		Specification
Rated voltage		13.5V, 110A
Speed in use		1,000 ~ 18,000 rpm
Voltage regulator		IC Regulator built-in type
Regulator Setting Voltage	External mode	Refer to below graph
	Internal mode	14.55 ± 0.3V
Temperature Gradient	External mode	0 ± 3 mV / °C
	Internal mode	-3.5 ± 2mV / °C

※ Regulator Setting Voltage (External mode)

Alternator Description and operation

Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In additi ...

Alternator Components and components location

Components 1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket 3. Front Bearing 4. Stator 5. Rotor 6. Rear Bearing 7. Rear ...

Other information:

Kia Cee'd JD Service Manual: Rain Sensor Repair procedures
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switc ...

Kia Cee'd JD Service Manual: Crash Pad Lower Panel Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...