Kia Cee'd: Heating,Ventilation, Air Conditioning / Blower
- Blower Unit Components and components location
- Blower Unit Repair procedures
- Blower Motor Repair procedures
- Blower Resistor (Manual) Repair procedures
- Power Mosfet (DATC) Repair procedures
- Climate Control Air Filter Description and operation
- Climate Control Air Filter Repair procedures
- Intake Actuator Description and operation
- Intake Actuator Repair procedures
PTC Heater (Gasoline Engine) Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
...
Blower Unit Components and components location
Component Location
Components
1. Intake Seal
2. Intake Upper Case
3. Intake Actuator
4. Climate control air filter
5. Climate control ...
Other information:
: Cleaning the Exterior
Cleaning the Exterior Precautions
Immediately remove fuel spillages, AdBlue
residuals, bird droppings, insect deposits
and road tar. These may cause damage to
your vehicle’s paintwork or trim over time.
Remove any exterior accessories, for
example antennas, before entering a car
wash.
Cleanin ...
: Installing a Child Restraint in a Center Seat. Combining the Seatbelt and
Lower Anchors for Attaching Child Restraints
Installing a Child Restraint in a Center Seat
WARNING: The standardized
spacing for LATCH lower anchors is 11 in
(280 mm) center to center. Do not use
LATCH lower anchors for the center
seating position unless the child restraint
manufacturer's instructions permit and
specify using anchors spa ...
