Kia Cee'd: Automatic climate control system / Checking the amount of air conditioner refrigerant and compressor lubricant

Kia Cee'd JD Owners Manual / Features of your vehicle / Automatic climate control system / Checking the amount of air conditioner refrigerant and compressor lubricant

When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a bad influence on the air conditioning system.

Therefore, if abnormal operation is found, we recommend that the system be inspected by an authorized Kia dealer.

WARNING - Vehicles equipped with R-134a*

Because the refrigerant is at very high pressure, the air conditioning system should only be serviced by trained and certified technicians. It is important that the correct type and amount of oil and refrigerant is used. Otherwise, it may cause damage to the vehicle and personal injury.

WARNING - Vehicles equipped with R-1234yf*

Because the refrigerant is mildly inflammable and at very high pressure, the air conditioning system should only be serviced by trained and certified technicians. It is important that the correct type and amount of oil and refrigerant is used.

Otherwise, it may cause damage to the vehicle and personal injury.

Climate control air filter
The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system ...

Windshield defrosting and defogging
WARNING - Windshield heating Do not use the position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield cou ...

Other information:

Kia Cee'd JD Service Manual: ESP OFF Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center lower panel. (Refer to Crash Pad - "Crash Pad Center Panel") 3. Remove the center facia switch ass ...

Kia Cee'd JD Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end ...

© 2017-2024 www.kceed.com