Kia Cee'd: Dual Clutch Transmission Control System / Clutch Actuator Motor 1 (Odd Gear) Repair procedures

Inspection
1.
Turn off the ignition switch.
2.
Disconnect the clutch motor connector (A).

3.
Measure the resistance on the clutch motor terminal.
4.
Refer to the specifications and check that the measured resistance is as specified.
(Refer to Clutch Actuator Motor 1 - "Specification")
Removal
1.
Turn off the ignition switch and then disconnect the battery (-) cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
4.
Remove the ECM.
(Refer to Fuel System - "Engine Control Module (ECM)")
5.
Disconnect the clutch actuator motor connector (A).

6.
Loosen the mounting screw, and then remove the clutch actuator motor (A).
Tightening Torque :
4.4 ~ 5.4 N.m (0.45 ~ 0.55 kgf.m, 3.3 ~ 4.0 lb-ft)

Installation
1.
Install in the reverse order of removal.
  
Clutch actuator spline (A) with grease before installation.
Specified grease [CSG-101M (0.1ml)]

Clutch Actuator Motor 1 (Odd Gear) Schematic diagrams
Schematic Diagrams ...

Clutch Actuator Motor 2 (Even Gear) Description and operation
Description The clutch actuator motor is mounted on the Dual Clutch Transmission(DCT). The clutch actuator motor comprises an actuator motor that controls the odd clutch and a ...

Other information:

Kia Cee'd JD Service Manual: Front Wheel Speed Sensor Components and components location
Components   1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

Kia Cee'd JD Owners Manual: Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer. - Normal wiper operation --- - Intermittent wipe O - Wiper is not in operation Push the lever away from you to ...

© 2017-2026 www.kceed.com