Kia Cee'd: Crash Pad / Crash Pad Side Cover Repair procedures
[LH]
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Put on gloves to protect your hands.
|
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Using a screwdriver or remover, remove the crash pad side cover [LH]
(A).
|
| 2. |
Install in the reverse order of removal.
| •
|
Replace any damaged clips.
|
|
|
[RH]
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Put on gloves to protect your hands.
|
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Using a screwdriver or remover, remove the crash pad side cover [RH]
(A).
|
| 2. |
Disconnect the passenger air bag on/off switch connector (A).
|
| 3. |
Install in the reverse order of removal.
| •
|
Make sure the connector are connected in properly.
|
| •
|
Replace any damaged clips.
|
|
|
Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Component Location
1. Main crash pad assembly
...
Other information:
Kia Cee'd JD Service Manual: Temperature Control Actuator Description and operation
Description
The heater unit includes mode control actuator and temperature control actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the procedure as follows. Signal from the control unit adjusts
the position of the ...
Kia Cee'd JD Owners Manual: Inside light (5 Door and Wagon)
1. Turn off the engine.
2. Open the tailgate.
3. Remove the service cover using a flatblade
screwdriver.
4. Loosen the retaining nuts.
5. Disconnect the power connector.
6. Remove the rear combination light
assembly from the body of the vehicle.
Tail light or tail and stop light (Bul ...
Crash Pad Side Cover Components and components location
Main Crash Pad Assembly Components and components location