Kia Cee'd: Instrument cluster (Super vision) / Dual clutch transmission (DS mode) shift indicator
The indicator displays which Dual clutch transmission shift lever is selected.
In DS mode, the “S” indicator displays with “SPORTS” indicator in cluster. For more detailed information about DS mode, refer to the chapter 5.
CAUTION - DCT
- When the problem of gear system occurs, the transaxle indicator will blink. For your safety, we recommend that you contact an authorized Kia dealer and have the system checked.
- When the clutch is overheated, the safe protection mode operates. According to the safe protection mode, the transaxle indicator blinks with buzzer sound. The buzzer beeps 3 times. In this time, the LCD warning about safe protection mode also displays. In this condition, the driving may not be smoothly. If you ignore this warning, the driving condition is getting worse and the system may have problem. To return the normal driving condition, apply the foot brake and stop the vehicle for few minutes before driving off.
Automatic Transaxle Shift Indicator in
sports mode
In the Sports Mode, this indicator informs
which gear is desired while driving to
save fuel.
For example
: Indicates that shifting up to
the 3rd
gear is desired (currently the shift
leve ...
Speed limiter indicator
The indicator illuminates when the speed
limit control system is enabled by move
the lever up on the steering
wheel.
The indicator goes off when the
lever
up again to deactivate the sys ...
Other information:
Kia Cee'd JD Owners Manual: Driver position memory system
A driver position memory system is provided
to store and recall the driver seat
position with a simple button operation.
By saving the desired position into the
system memory, different drivers can
reposition the driver seat based upon
their driving preference. If the battery is
disc ...
Kia Cee'd JD Service Manual: Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must
be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" ...