Kia Cee'd: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2 at C.T.
and W.O.T.
|
Specification: Refer to “Specification”
|
|
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Specification: Refer to “Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the ETC module (A) from
the engine.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
|
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning procedure
must be performed.
| 1. |
Hold the ignition key or the start button at th IG ON position during
5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
|
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure
does not performed after replacing ETC module.
|
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfer ...
Other information:
: Maintenance Precautions
Service your vehicle regularly to help
maintain its roadworthiness and resale
value. There is a large network of
authorized dealers that are there to help
you with their professional servicing
expertise. We believe that their specially
trained technicians are best qualified to
service your ve ...
Kia Cee'd JD Owners Manual: Windshield washers (front)
In the O (Off) position, pull the lever gently
toward you to spray washer fluid on
the windshield and to run the wipers 1-3
cycles.
Use this function when the windshield is
dirty.
The spray and wiper operation will continue
until you release the lever.
If the washer does not work, che ...
ETC (Electronic Throttle Control) System Schematic diagrams
Manifold Absolute Pressure Sensor (MAPS) Description and operation