Kia Cee'd: Front light replacement / Follow the steps 1 to 7 from the previous chapter.
8. Remove the cover by turning it counterclockwise.
9. Disconnect the headlight bulb socketconnector.
10. Unsnap the headlight bulb retaining wire by depressing the end and pushing it upward.
11. Remove the bulb from the headlight assembly.
12. Install a new headlight bulb and snap the headlight bulb retaining wire into position by aligning the wire with the groove on the bulb.
13. Connect the headlight bulb socket connector.
14. Install the headlight bulb cover by turning it clockwise.
15. Connect the power connector to the back of the headlight assembly.
Position light (3, bulb type)
Follow the steps 1 to 9 from the previous
page.
10. Pull out the socket from the assembly.
11. Pull the bulb out of the socket.
12. Insert a new bulb into the socket.
13. Install the socket into ...
Other information:
Kia Cee'd JD Service Manual: Transmission Control Module (TCM) Repair procedures
Inspection
Transmission Control Module (TCM) Inspection
Procedure
1.
Inspecting TCM ground circuit: Measure the resistance between the TCM
and chassis ground.
(Check the terminal connected to the chassis ground while using the
ba ...
Kia Cee'd JD Service Manual: Manifold Absolute Pressure Sensor (MAPS) Description and operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM. By
using this signal, the ECM calcul ...
