Kia Cee'd: Front Door / Front Door Window Glass Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Repair procedures

Replacement

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

2.	Remove the front door belt inside weatherstrip (A).

Remove the front door window glass mounting hole plug (B).

•	Be careful not to drop the glass and/or scratch the glass surface.

•	Use the door switch to align the mounting hole/bolt with the hole in the door.

•	If unable to operate the window motor, remove the motor and align the hole by hand.

Carefully adjust the front door window glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :

3.9 ~ 2.9 N.m (0.4 ~ 1.2 kgf.m, 11.8 ~ 8.7 lb-ft)

Install in the reverse order of removal.

•	Roll the glass up and down to see if it moves freely without binding.

•	Adjust glass position as needed.

•	Make sure the door lock and opens properly.

•	Replace any damaged clips.

Front Door Window Glass Components and components location

Component Location 1. Front door window glass ...

Front Door Module Components and components location

Component Location 1. Front door module ...

Other information:

Kia Cee'd JD Service Manual: Manifold Absolute Pressure Sensor (MAPS) Description and operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calcul ...

Kia Cee'd JD Service Manual: Repair procedures
On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...