Kia Cee'd: Hood / Hood Latch Release Handle Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement

1.	Using a screwdriver or remover, remove the hood latch release handle (A).

Install in the reverse order of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle Components and components location

Component Location 1. Hood latch release handle ...

Hood Latch Components and components location

Component Location 1. Hood latch assembly ...

Other information:

Kia Cee'd JD Service Manual: Engine Control Module (ECM) Repair procedures
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" ...

Kia Cee'd JD Owners Manual: Electronic Stability Control (ESC) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions. Under normal driving conditions, the ESC indicator will remain off. When a slippery or low traction condit ...