Kia Cee'd: Engine Control System / ISG (Idle Stop & Go) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / ISG (Idle Stop & Go) Repair procedures

Inspection

1.	Remove the ISG switch from the switch assembly.

2.	Check the continuity between the switch 3 and 6 terminals as the ISG OFF switch is engaged.

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the crash pad low switch assembly (A) from the switch panel on the crach pad of the driver's side.

Installation

1.	Installation is reserve of removal.

ISG (Idle Stop & Go) Description and operation

Description Idle Stop & Go (ISG) system switches off the ignition when vehicle is stopped, and then restarts the ignition and starts the vehicle when accelerator is pushed. I ...

ISG (Idle Stop & Go) Schematic diagrams

Schematic Diagram 1. C-CAN High/Low 2. MIL. Lamp 3. Immobilizer 4. Canister 5. Manifold Absolute Pressure Sensor (MAPS) 6. Intake Air Temperat ...

Other information:

Kia Cee'd JD Service Manual: Smart Key Unit Components and components location
Component Connector Pin Information No. Connector A(26 pins) No. Connector B(16 pins) No. Connector C(22 pins) 1 Battery power load 1 CAN H ...

Kia Cee'd JD Service Manual: Schematic diagrams
Schematic Diagrams MDPS Circuit Diagram Harness Connector Connector Pin no Pin name Battery 1 Battery + 2 Battery - Vehicle signal ...