Inspection |
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery voltage
(12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V) and check
that the motor operates smoothly. Next, reverse the polarity and check
that the motor operates smoothly in the reverse direction. If the operation
is abnormal, replace the motor.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V) and check
that the motor operates smoothly. Next, reverse the polarity and check
that the motor operates smoothly in the reverse direction. If the operation
is abnormal, replace the motor.
|
Kia Cee'd JD Service Manual: Knock Sensor (KS) Description and operation
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block
and senses engine knocking.
When knocking occurs, the vibration from the cylinder block is applied as pre ...
Kia Cee'd JD Owners Manual: Outside light
Rear turn signal light and stop/tail light
1. Turn off the engine.
2. Open the tailgate.
3. Loosen the light assembly retaining
screws with a cross-tip screwdriver.
4. Remove the rear combination light
assembly from the body of the vehicle.
5. Remove the socket from the assembly
by tu ...