Kia Cee'd: Emergency starting / Push-starting

Your manual transaxle-equipped vehicle should not be push-started because it might damage the emission control system. Vehicles equipped with automatic transaxle cannot be push-started. Follow the directions in this chapter for “Jumpstarting”.

WARNING

Never tow a vehicle to start it because the sudden surge forward when the engine starts could cause a collision with the tow vehicle.

Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly rec ...

If the engine overheats
If your temperature gauge indicates overheating, you will experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull of ...

Other information:

Kia Cee'd JD Service Manual: Side Impact Sensor (SIS) Repair procedures
Removal Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the door scuff trim. (Refer to Body - "Door scuff trim") ...

Kia Cee'd JD Service Manual: Engine Control Module (ECM) Repair procedures
Removal    When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" ...

© 2017-2026 www.kceed.com