Kia Cee'd: Interior Trim / Rear Wheel House Trim Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Wheel House Trim Repair procedures

Replacement
[5Door]
  
Put on gloves to protect your hands.
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear shelf side trim.
(Refer to Interior Trim - "Rear Shelf Side Trim")
3.
After loosening the mounting bolt and screw, then remove the rear wheel house trim (A).

4.
Install in the reverse order of removal.
  
Replace any damaged clips.
[3Door]
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear shelf side trim.
(Refer to Interior Trim - "Rear Shelf Side Trim")
4.
After loosening the mounting clip and screw, then remove the rear wheel house trim (A).

5.
Install in the reverse order of removal.
  
Replace any damaged clips.
Rear Wheel House Trim Components and components location
Component Location [5Door]   1. Rear wheel house trim [3Door]   1. Rear wheel house trim ...

Rear Transverse Trim Components and components location
Component Location   1. Rear transverse trim ...

Other information:

Kia Cee'd JD Owners Manual: Non-operating condition
The sensors are located inside of the rear bumper. Always keep the rear bumper clean for the system to work properly. WARNING The warning light on the outside rearview mirror will illuminate whenever a vehicle is detected at the rear side by the system. To avoid accidents, do ...

Kia Cee'd JD Service Manual: Special service tools
Special Service Tools   Tool Name / Number Illustration Description Engine support fixture (bar) 09200-3N000 Used for holding engine assembly when removing / installing transaxle Used ...

© 2017-2024 www.kceed.com