Kia Cee'd: Charging System / Alternator Description and operation

Kia Cee'd JD Service Manual / Engine Electrical System / Charging System / Alternator Description and operation

Description

The Alternator has eight built-in diodes, each rectifying AC current to DC current.

Therefore, DC current appears at alternator "B" terminal.

In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.

The alternator is regulated by the battery voltage detection system.

The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.

The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. Drive belt pulley
3. Rotor
4. Stator
5. Rectifier

Repair procedures

On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform tro ...

Alternator Specifications

Specification Alternator [Non-ISG type] Item Specification Rated voltage 13.5V, 90A Speed in use ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Inspection Signal Circuit Inspection 1. Check ignition lock switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". (2) Disconnect ignition lock switch connector ...

Kia Cee'd JD Service Manual: Rear Seat Belt Retractor Repair procedures
Replacement • When installing the belt, make sure not to damage the retractor. 1. Remove the rear pillar trim. (Refer to Inte ...