Kia Cee'd: Charging System / Alternator Repair procedures

Kia Cee'd JD Service Manual / Engine Electrical System / Charging System / Alternator Repair procedures

Removal

1.	Disconnect the battery negative terminal.

2.	Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise to loosen tension.

3.	Remove the drive belt (A).

4.	Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C).

5.	Remove the alternator (A).

Installation

1.	Install in the reverse order of removal.

Adjust the alternator belt tension after installation.

(Refer to Engine Mechanical System - "Drive Belt")

Alternator installation bolt:

[12mm (0.47in) bolt]

19.6 ~ 26.5 Nm (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 Ib-ft)

[14mm (0.55in) bolt]

29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

Disassembly

1.	Remove the rear cover (A) after removing nuts.

2.	Remove the mounting bolts (A) and the brush holder assembly (B).

3.	Remove the slip ring guide (A) after pulling it.

Remove the OAD(Overrunning Alternator Decoupler) cap.

•	When installing, replace with new OAD cap.

5.	Remove the OAD(Overrunning Alternator Decoupler) pulley (A) using the special tool.

6.	Unsolder the 3 stator leads (A).

7.	Remove the 4 through bolts (A).

8.	Disconnect the rotor (A) and bracket (B).

Reassembly

Reassemble in the reverse order of disassembly.

•	When reassembling OAD pulley, replace with new OAD cap.

Inspection

[Rotor]

1.	Check that there is continuity between the slip rings (C).

2.	Check that there is no continuity between the slip rings and the rotor (B) or rotor shaft (A).

3.	If the rotor fails either continuity check, replace the alternator.

[Stator]

1.	Check that there is continuity between each pair of leads (A).

2.	Check that there is no continuity between each lead and the coil core.

3.	If the coil fails either continuity check, replace the alternator.

Alternator Schematic diagrams

Circuit Diagram ...

DC DC Converter Description and operation

Description Due to the considerably more frequent occurrence of starting operations, the electrical load that occurs often leads to voltage dips in the vehicle network. In ord ...

Other information:

Kia Cee'd JD Owners Manual: Engine compartment precautions (Diesel engine)
The injector operates at high voltage (maximum 200v). Therefore, the following accidents may occur. - Direct contact with the injector or injector wiring may cause electric shock or damage your muscle or nerve system. - The electromagnetic wave from the operating injector ma ...

: SYNC™ Troubleshooting
Your SYNC system is easy to use. However, should questions arise, see the tables below. Use your regional Ford website at any time to check your phone's compatibility, register your account and set preferences as well as access a customer representative via an online chat (during certain hour ...