Kia Cee'd: Blind Spot Detection system / Blind Spot Detection Unit" Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover")

Remove the BSD unit (A) after loosening the mounting nuts.

[3.5 Door]

(LH)

(RH)

[Wagon]

(LH)

(RH)

Take care not to separate the bracket from rear bumper when removing the BSD sensor.

Installation

1.	Install the BSD units to the rear bumper.

2.	Install the rear bumper cover.

Connect the negative (-) battery terminal.

Take care not to confuse left side (master) and right side (slave) unit when installing.

BSD units connector connect to the wiring connector.

Circuit Diagram ...

Circuit Diagram ...

Kia Cee'd JD Service Manual: Blower Unit Components and components location
Component Location Components 1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Climate control air filter 5. Climate control air filter Cover 6. Intake Door 7. Intake Lower Case 8. NVH Pad 9. Blower Upper ...

Kia Cee'd JD Service Manual: Description and operation
Description Block Diagram LDWS is composed of below units No Item Function Position 1 LDWS UNIT 1) Lane Departure Warning System (LDWS) : Detects d ...