Kia Cee'd: Brake System / Brake Line Repair procedures

Kia Cee'd JD Service Manual / Brake System / Brake System / Brake Line Repair procedures

Removal

1.	Disconnect the brake fiuid level switch connector, and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservior with a syringe.

Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

3.	Remove the wheel & tire.

Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:

12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

5.	Remove the brake hose clip (A).

Disconnect the brake hose from the brake caliper by loosening the bolt (C).

Tightening torque:

24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Front

Rear

Inspection

1.	Check the brake tubes for cracks, crimps and corrosion.

2.	Check the brake hoses for cracks, damage and fluid leakage.

3.	Check the brake tube flare nuts for damage and fluid leakage.

4.	Check brake hose mounting bracket for crack or deformation.

Installation

Install in the reverse order of removal.

Use a new washer (A) whenever installing.

2.	After installation, bleed the brake system. (Refer to Brake system bleeding)

3.	Check the spilled brake oil.

Brake Line Components and components location

Components ...

Brake Pedal Components and components location

Components [LHD] 1. Cowl bracket 2. Brake pedal member assembly 3. Stop lamp switch 4. Return spring 5. Brake pedal 6. Bolt ...

Other information:

Kia Cee'd JD Owners Manual: Elapsed time
This mode indicates the total time traveled since the last driving time reset. Even if the vehicle is not in motion, the driving time keeps going while the engine is running. The meter’s working range is from 0:00~99:59. Pressing the button for more than 1 second, when the drivin ...

Kia Cee'd JD Service Manual: Cluster Fascia Panel Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...