Kia Cee'd: Troubleshooting / Compressor Oil Repair procedures

Oil Specification
1.
The R-134a or R-1234yf system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.
2.
Compressor oil (PAG) varies according to compressor model. Be sure to use oil specified for the model of compressor.
Handling of Oil
1.
The oil should be free from moisture, dust, metal powder, etc.
2.
Do not mix with other oil.
3.
The water content in the oil increases when exposed to the air. After use, seal oil from air immediately. (R-134a or R-1234yf compressor oil absorbs moisture very easily.)
4.
The compressor oil must be stored in steel containers, not in plastic containers.
Compressor Oil Check
The oil used to lubricate the compressor is circulating with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system
PAG OIL (FD46XG) : 110 ± 10cc
Oil Return Operation
There is close affinity between the oil and the refrigerant.
During normal operation, part of the oil recirculation with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows :
1.
Open all the doors and the engine hood.
2.
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.
3.
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.
4.
Stop the engine.
Air Conditioning System Components and components location
Component Location Index Engine Room   1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hos ...

Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. ...

Other information:

Kia Cee'd JD Service Manual: Shift Cable Components and components location
Components   1. Shift lever assembly  2. Shift cable assembly 3. Retainer 4. Bolt 5. Nut 6. Manual control lever 7. Knob ...

Kia Cee'd JD Service Manual: Rear Bumper Cover Repair procedures
Replacement    • Put on gloves to protect your hands.    • Use ...

© 2017-2024 www.kceed.com