Kia Cee'd: Manual Transaxle Control System / Control Shaft Complete Repair procedures

Kia Cee'd JD Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Repair procedures

Removal

1.	Move the shift lever to neutral gear position.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the control cable (B) from the control shaft after removing the pins (A).

Remove the control shaft complete (A).

Tightening torque :

19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)

Installation

1.	Install in the reverse order of removal.

•	Install the control shaft complete after setting the neutral state.

•

Apply the sealant to the contact surface of transaxle and control shaft.

Specified sealant : Anaerobic adhesive for flange

Control Shaft Complete Components and components location

Components Location 1. Control Shaft Complete ...

Dual Clutch Transmission(DCT) System

...

Other information:

Kia Cee'd JD Owners Manual: To install the barrier net
1. Open the cover (if equipped) for the holder position (1) or (2) you want to install. 2. Compress the one side net upper shaft to length direction before insert the net upper shaft into the large hole (3) and then secure by sliding into the small hole (4). 3. Hang the net strap ...

Kia Cee'd JD Service Manual: Muffler Repair procedures
Removal and Installation [Front muffler] 1. Disconnect the rear oxygen sensor connector (A). 2. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ...