Kia Cee'd: Starting System / Description and operation

Kia Cee'd JD Service Manual / Engine Electrical System / Starting System / Description and operation

Description

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.

The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

In conjunction with the ISG function, the starter motor must do a great deal more work. Therefore, the starter motor is configured for a significantly higher number of start cycles. The components of the starter motor have been adapted to the higher requirements.

•	There are two kinds of starter, ISG type starter and Non-ISG type. When replace the starter, confirm that the part number and connector shape.

•	ISG (Idle stop & go) system equipped vehicle always use the ISG type starter only. If the other starter has installed, this can potentially lead to engine electrical trouble or ISG system error.

•	Do not disassemble the ISG type starter. If the starter troubles occur, replace the starter.

[ISG Type]

1. Solenoid
2. Brush assembly
3. Armature
4. Overrun clutch

[Non-ISG Type]

1. Switch assembly
2. Yoke assembly
3. Armature
4. Over runing clutch

Starting System

...

Troubleshooting

Troubleshooting • The battery must be in good condition and fully charged for ...

Other information:

Kia Cee'd JD Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Set the front tires straight-ahead before removing the steering wheel. If the steering wheel and the front tires are not set straight ahead toget ...

Kia Cee'd JD Service Manual: Panoramaroof Assembly Repair procedures
Replacement [Removal] 1. Remove the roof trim. (Refer to Roof Trim - "Roof Trim Assembly") 2. Remove the roof antenna. 3. Remove the movable glass. (Refer to Panoramaroof - ...