Kia Cee'd: Maintenance / Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Maintenance book in your vehicle.
Your vehicle is equipped with an emission control system to meet all emission regulations.
There are three emission control systems which are as follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to assure the proper function of the emission control systems, it is recommended that you have your car inspected and maintained by an authorized Kia dealer in accordance with the maintenance schedule.
Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)
- • To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch.
- • After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.
- 1. Crankcase emission control system
- 2. Evaporative emission control System
- 3. Exhaust emission control system
- Lean NOx Trap
Cleaning the interior window glass
If the interior glass surfaces of the vehicle
become fogged (that is, covered with
an oily, greasy or waxy film), they should
be cleaned with glass cleaner. Follow the
directions on the glass ...
1. Crankcase emission control
system
The positive crankcase ventilation system
is employed to prevent air pollution
caused by blow-by gases being emitted
from the crankcase. This system supplies
fresh filtered air to the crankcas ...
Other information:
Kia Cee'd JD Service Manual: Steering Angle Sensor Description and operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering)
and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from th ...
Kia Cee'd JD Service Manual: ISG (Idle Stop & Go) Repair procedures
Inspection
1.
Remove the ISG switch from the switch assembly.
2.
Check the continuity between the switch 3 and 6 terminals as the ISG
OFF switch is engaged.
Removal
1.
Tur ...
