Kia Cee'd: Front Suspension System / Front Lower Arm Repair procedures

Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Remove the lower arm (A) from the knuckle.
Tightening torque:
98.0~117.6 N.m(10.0~12.0 kgf.m, 72.3~86.7 lb-ft)

4.
Loosen the bolts and nuts and then remove the front lower arm (A).
Tightening torque
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

Tightening torque
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)

5.
Install in the reverse order of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
3.
Check the all bolts and nuts.
Front Strut Assembly Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front w ...

Front Stabilizer Bar Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front w ...

Other information:

Kia Cee'd JD Service Manual: Transmission Control Module (TCM) Description and operation
Description The Transmission Control Module (TCM) is like the brain for the Dual Clutch Transmission (DCT). It receives information from various sensors for a wide range of transmission controls to provide an optimal driving environment for the driver. The TCM is programmed ...

Kia Cee'd JD Service Manual: Clutch Actuator Motor 2 (Even Gear) Repair procedures
Inspection 1. Turn off the ignition switch. 2. Disconnect the clutch motor connector (A). 3. Measure the resistance on the clutch motor terminal. 4. Refer to the spec ...

© 2017-2025 www.kceed.com