Kia Cee'd: Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Open the tailgate and then remove the luggage side trim. (Refer to Body - "Luggage Side Trim")

3.	Disconnect the fuel filler door release actuator connector and remove the mounting nuts (2EA).

4.	Remove the fuel filler door release actuator (B) after removing the cable (A).

5.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Installation

1.	Install the fuel filler door release actuator cable.

2.	Install the fuel filler door release actuator.

3.	Connect the negative (-) battery terminal.

Components and components location

Components ...

Seat Electrical

...

Other information:

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Kia Cee'd JD Service Manual: Manual Transaxle Oil Repair procedures
Inspection Manual Transaxle Oil level Check • Check intervals: 40000 miles / 4years (60000 km / 4 years) • If a leak is dete ...