Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 2 Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Input Speed Sensor 2 Repair procedures

Inspection

Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.

Removal

1.	Turn off the ignition switch and then disconnect the battery (-) cable.

2.	Remove the under cover.

3.	Disconnect the input shaft speed sensor connector (A).

4.	Loosen the mounting bolt and then remove the input shaft speed sensor (B).

Installation

Install in the reverse order of removal.

Tightening torque :

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Input Speed Sensor 2 Schematic diagrams

Schematic Diagrams ...

Inhibitor Switch Description and operation

Description The inhibitor switch is mounted on the transmission case. It includes the electric switch plate circuit and is directly connected with the transmission lever via tran ...

Other information:

Kia Cee'd JD Owners Manual: Outside light
Rear turn signal light and stop/tail light 1. Turn off the engine. 2. Open the tailgate. 3. Loosen the light assembly retaining screws with a cross-tip screwdriver. 4. Remove the rear combination light assembly from the body of the vehicle. 5. Remove the socket from the assembly by tu ...

: Steering Wheel
Adjusting the Steering Wheel WARNING: Do not adjust the steering wheel when your vehicle is moving. Note: Make sure that you are sitting in the correct position. Unlock the steering column. Adjust the steering wheel to the desired position. Lock the steering column. Horn Press on the cen ...