Kia Cee'd: BSD (Blind Spot Detection) /
LCA (Lane Change Assist) / Non-operating condition

The sensors are located inside of the
rear bumper.
Always keep the rear bumper clean for
the system to work properly.
WARNING
- The warning light on the outside
rearview mirror will illuminate
whenever a vehicle is detected at
the rear side by the system.
To avoid accidents, do not focus
only on the warning light and neglect
to see the surrounding of the
vehicle.
- Drive safely even though the vehicle
is equipped with a Blind Spot
Detection System (BSD) and Rear
Cross Traffic Alert (RCTA). Do not
solely rely on the system but check
your surrounding before changing
lanes or backing the vehicle up.
The system may not alert the driver
in some conditions so always
check your surroundings while
driving.
- The Blind Spot Detection System
(BSD) and Rear Cross Traffic Alert
(RCTA) are not a substitute for
proper and safe driving practices.
Always drive safely and use caution
when changing lanes or backing
up your vehicle.The Blind Spot
Detection System (BSD) may not
detect every object alongside the
vehicle.
✽ NOTICE
- The system may not work properly
when the bumper has been damaged,
or if the rear bumper has been
replaced or repaired.
- The sensing range differs somewhat
according to the width of the road.
When the road is narrow, the system
may detect other vehicles in the next
lane Or when the road is wide, the system
may not detect other vehicles in
the next lane.
- The system may turn off due to strong
electromagnetic waves.
To operate:
Press the BSD switch with the Ignition
switch in the ON position.
The indicator on the BSD switch will illuminate.
When the vehicle speed exceeds 30
km/h (20 mph), the system will ...
• This warning message may appear
when :
- One or both of the sensors on the
rear bumper is blocked by dirt or snow
or a foreign object.
- Driving in rural areas where the BSD
sensor doe ...
Other information:
Kia Cee'd JD Owners Manual: Tire chains
Since the sidewalls of radial tires are
thinner, they can be damaged by mounting
some types of snow chains on them.
Therefore, the use of snow tires is recommended
instead of snow chains. Do
not mount tire chains on vehicles
equipped with aluminum wheels; snow
chains may cause damage ...
: Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies
Clearing the Garage Door Opener
Press and hold the outer two function
buttons simultaneously for
approximately 10 seconds until the
indicator light above the buttons
flashes rapidly.
When the indicator light flashes,
release the buttons.
Note: You cannot erase individual buttons.
Repr ...