Kia Cee'd: Lighting / Operating condition

1.Place the light switch in the AUTO position.

2.Turn on the high beam by pushing the lever away from you.

The high beam assist indicator will illuminate.

3.The High Beam Assist will turn on when vehicle speed is above 45km/h.

4. If the light switch is placed to the headlight position, the high beam assist will turn off and the low beam will be on constantly.

The high beam switches to low beam in the below conditions.

- When headlight is detected from oncoming vehicle
- When tail light is detected from the front vehicle.
- When streetlight or other light is detected.
- When the high beam assist turns off
- When vehicle speed is below 35km/h

CAUTION

The system may not operate normally in the below conditions.

CAUTION

WARNING

High Beam Assist (HBA)
The high beam assist is a system that automatically adjusts headlamp range (switches between high beam and low beam) according to the brightness of other vehicles and road conditions. ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which tur ...

Other information:

Kia Cee'd JD Service Manual: Center Pillar Trim Components and components location
Component Location [5Door]   1. Center pillar lower trim 2. Center pillar upper trim [3Door]   1. Rear inner outer trim 2. Center pillar upper trim ...

Kia Cee'd JD Service Manual: BJ Boot Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Rem ...

© 2017-2024 www.kceed.com