Kia Cee'd: Troubleshooting / Photo Sensor Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / Photo Sensor Repair procedures

Inspection

1.	Turn the ignition switch ON.

2.	Connect the GDS.

3.	Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.

The voltage will rise with higher intensive light and reduce with lower intensive light.

1. Auto Light Signal
2. Auto Light Ground
3. Photo Signal (RH)
4. LED Power (Battery)

5. LED Ground (To BCM)
6. Photo Signal (LH)
7. Photo Power (SW)
8. Auto Light Power (5V)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	With a flat-head screwdriver, remove the photo sensor (A) from the center of the defrost nozzle after disconnecting the connector (B).

3.	Install in the reverse order of removal.

Photo Sensor Description and operation

Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation recei ...

Ambient Temperature Sensor Description and operation

Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increas ...

Other information:

Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be removed as follows: 1. Turn off the engine. 2. Disconnect the negative battery cable. 3. Remove the fuse panel on the right side in the engine compartment. 4. Remove the nuts shown in the picture above. 5. Replace the fuse with a new one of the s ...

Kia Cee'd JD Service Manual: Airbag Module Disposal Description and operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be deployed. If the vehicle is still within the warranty peri ...