Kia Cee'd: Rear Door / Rear Door Latch Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch Repair procedures

Replacement

1.	Remove the rear door module. (Refer to Rear Door - "Rear Door Module")

2.	Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.

3.	Disconnect the rear door outside handle cable (A).

4.	Disconnect the rear door latch connector (B).

5.	Remove the rear door latch assembly (A) by pulling it.

6.	Remove the rear door inside handle cable (A) by pulling it.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Make sure the door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Rear Door Latch Components and components location

Component Location 1. Rear door latch ...

Rear Door Belt Outside Weatherstrip Repair procedures

Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, ...

Other information:

Kia Cee'd JD Service Manual: CVVT Oil Control Valve (OCV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within t ...

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting Ignition System Symptom Suspect Area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch Inspect ignition lock switch, or replace as requ ...