Kia Cee'd: Rear Seat / Rear Seat Cushion Cover Repair procedures
[5Door, Waggon]
[LH]
| • |
Put on gloves to protect your hands.
|
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the rear seat cushion assembly [LH].
(Refer to Rear Seat - "Rear Seat Assembly")
|
| 2. |
Disconnect the rear seat cushion cover protector (A).
|
| 3. |
Remove the rear seat cushion frame (A).
|
| 4. |
After removing the hog-ring clips (A) on the rear of seat cushion and
remove the rear seat cushion cover (B).
|
| 5. |
Install in the reverse order of removal.
| •
|
To prevent wrinkles, make sure the material is stretched
evenly over the cover (B) before securing the hog-ring
clips (A).
|
| •
|
Replace the hog-ring clips with new ones using special
tool [C (09880-4F000)].
|
|
|
[5Door, Waggon]
[RH]
| • |
Put on gloves to protect your hands.
|
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the rear seat cushion assembly [RH].
(Refer to Rear Seat - "Rear Seat Assembly")
|
| 2. |
Disconnect the rear seat cushion cover protector (A).
|
| 3. |
Remove the rear seat cushion frame (A).
|
| 4. |
After removing the hog-ring clips (A) on the rear of seat cushion and
remove the rear seat cushion cover (B).
|
| 5. |
Install in the reverse order of removal.
| •
|
To prevent wrinkles, make sure the material is stretched
evenly over the cover (B) before securing the hog-ring
clips (A).
|
| •
|
Replace the hog-ring clips with new ones using special
tool [C (09880-4F000)].
|
|
|
[3Door]
| • |
Put on gloves to protect your hands.
|
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the j hook (A).
|
| 2. |
After removing the hog-ring clips (A) on the rear of seat cushion and
remove the rear seat cushion cover (B).
|
| 3. |
Install in the reverse order of removal.
| •
|
To prevent wrinkles, make sure the material is stretched
evenly over the cover (B) before securing the hog-ring
clips (A).
|
| •
|
Replace the hog-ring clips with new ones using special
tool [C (09880-4F000)].
|
|
|
Component Location
1. Rear seat cushion cover [LH]
2. Rear seat cushion cover [RH]
...
Component Location
[5Door, Waggon only]
1. Rear back armrest
...
Other information:
Kia Cee'd JD Owners Manual: Blade inspection
✽ NOTICE
Commercial hot waxes applied by automatic
car washes have been known to
make the windshield difficult to clean.
Contamination of either the windshield or
the wiper blades with foreign matter can
reduce the effectiveness of the windshield
wipers. Common sources of contaminati ...
Kia Cee'd JD Owners Manual: Emergency braking
If there is a problem with the brake pedal
while driving, emergency braking is possible
by pulling up and holding the EPB
switch. Braking is possible only while you
are holding the EPB switch.
WARNING
Do not operate the parking brake
while the vehicle is moving except
in an emergency s ...
Rear Seat Cushion Cover Components and components location
Rear Back Armrest Components and components location