Kia Cee'd: Clutch Release Cylinder / Repair procedures
| 1. |
Check the clutch release cylinder for fluid leakage.
|
| 2. |
Check the clutch release cylinder boot for damage.
|
| 1. |
Drain the brake fluid through the bleed plug (A).
| •
|
Do not spill brake fluid on the vehicle; it may damage
the paint if brake fluid does contact the paint, wash
it off immediately with water.
|
|
|
| 2. |
Remove the clutch release cylinder assembly (C) after removing the tube
(B) and bolts (A-2ea).
|
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m,10.8 ~ 15.9 lb-ft)
|
|
| 1. |
Install in the reverse order of removal.
|
Apply the specified grease to the pushrod end.
|
|
Specified grease: CASMOLY L9508
Quantity: 0.4 ~ 0.8 g
|
|
| Clutch Release Cylinder Air Bleeding
Procedure |
| • |
Use the specified fluid. Avoid mixing different brands of fluid.
|
|
| 1. |
After disconnecting a cap from the clutch release cylinder air bleeder,
insert a vinyl hose in the plug.
|
| 2. |
Refill the clutch master cylinder with the specified fluid.
|
Specified fluid: SAE J1703 (DOT 3 or DOT 4)
|
|
| 3. |
Loosening the plug screw, press and release the clutch pedal about 10
times.
|
| 4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards, raise
the pedal with a hand.
|
| 5. |
After pressing the clutch pedal 3 times more, loosen the plug (A) and
re-tighten it with the pedal pressed. Raise it again, then.
|
| 6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
|
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.0 ~ 7.2 lb-ft)
|
|
| 7. |
Refill the clutch master cylinder with the specified fluid.
|
Specified fluid: SAE J1703 (DOT 3 or DOT 4)
|
|
Components
1. Union bolt
2. Gasket
3. Tube joint
4. Clutch tube
5. Valve plate
6. Valve spring
7. Bleeder screw
8. Release cylinder
...
Components and components location
