Kia Cee'd: Fuel Filler Door / Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

1.	Remove the fuel filler door release actuator.

2.	Open the fuel filler door.

After loosening the mounting screws, then remove the fuel filler door packing (A).

Tightening torque :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Pull out the fuel filler door open switch (A) outside of the trunk by pushing in the lock pins located inside the trunk.

5.	Pull out the fuel filler door cable (A) outside of the trunk by pushing in the lock pins located inside the trunk.

Remove the fuel filler door housing (A).

•	Pull out from inside of the packing part (B) When removing the fuel filler door housing.

Install in the reverse order of removal.

•	Make sure the fuel filler door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Component Location 1. Fuel filler door ...

...

Kia Cee'd JD Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" ...

Kia Cee'd JD Service Manual: Rear Seat Belt Buckle Repair procedures
Replacement 1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly") 2. Disconnect the rear seat belt buckle connector (B). 3. Loosen the mounting bolt, and ...