Kia Cee'd: Smart Key System / Smart Key Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Smart Key System / Smart Key Repair procedures

Smart Key

Smart Key Code Saving

1.	Connect the DLC cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.

2.	Select the vehicle model and then do "Smart key code saving".

3.	After selecting "Smart key teaching" menu, push "Enter" key, then the screen will be shown as below.

4.	After pushing the SSB with the teaching key, press "OK" button.

5.	Input the "Pin code" for first key teaching.

6.	Confirm the message "First key teaching completed".

7.	Input the "Pin code" for second key teaching.

8.	Confirm the message "Second key teaching completed".

9.	Then the screen will be shown as below when key teaching process is completed.

Smart Key Diagnostic Repair procedures

Inspection Self Diagnosis With GDS Smart key system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosi ...

Smart Key Unit Components and components location

Component Connector Pin Information No. Connector A(26 pins) No. Connector B(16 pins) No. Connecto ...

Other information:

Kia Cee'd JD Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal ...

Kia Cee'd JD Service Manual: PAB ON/OFF Switch Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the crash pad side cover. (Refer ...