Kia Cee'd: Dual Clutch Transmission Assembly / Transmission Gear Oil Repair procedures

Inspection
  
In principle, the transmission oil is maintenance-free, and no exchange is required.
But it must be inspected and replenished every 4 years or 40,000 miles.
1.
Park the vehicle on flat ground and turn off the engine.
2.
Remove the oil filler plug (A), and check the oil state and oil level.

3.
If the oil is dirty, loosen the oil drain plug (B) and drain the oil. Then fill with new oil.

Replacement
  
In principle, the Dual Clutch Transmission (DCT) oil is not changed under normal driving conditions.
However, under harsh driving conditions, it must be changed every 80,000 miles.
Harsh driving conditions are as follows:
High frequency driving on rough roads (bumpy roads, sand and gravel roads, snow-covered roads, and unpaved roads)
Frequent driving on mountain trails and inclines
In case the vehicle is used as a police vehicle, taxi, or for commercial or towing purposes
Frequent high speed driving (over 170 km/h)
In case of driving 50% or more of the total mileage in hot temperatures above 32°C and congested traffic
1.
Remove the drain plug (A) and drain all the oil. Then replace the drain plug.
Drain plug tightening torque:
58.8 ~ 78.4 N.m (6.0 ~ 8.0 kgf.m, 43.2 ~ 57.6 lb-ft)

  
The drain plug gasket must be replaced with a new one.
2.
Remove the oil filler plug (A) and fill with approximately 1.9 liters of new oil. Then replace the removed oil filler plug.

Transmission Gear Oil Specifications
Specified Lubricant   Item Specified lubricant Capacity Transmission oil SAE 75W/85, API GL-4 Approx. ...

Dual Clutch Transmission Control System
...

Other information:

: SYNC™ 3 Troubleshooting
Voice Recognition USB and Bluetooth Audio Phone Navigation (If Equipped) Apps Wi-Fi Connectivity Personal Profiles (If Equipped) Resetting the System Simultaneously press and hold the seek up and the audio unit power buttons until the screen goes black. Wait three minutes to all ...

Kia Cee'd JD Service Manual: CVVT & Camshaft Description and operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap ...

© 2017-2026 www.kceed.com