Kia Cee'd: Engine Control System / Accelerator Position Sensor (APS) Description and operation

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Rail Pressure Sensor (RPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine spee ...

Accelerator Position Sensor (APS) Specifications

Specification   Accelerator Position Output Voltage (V) [Vref=5V] APS1 APS2 C.T 0.7 ~ 0.8 ...

Other information:

Kia Cee'd JD Owners Manual: Finish maintenance
Washing To help protect your vehicle’s finish from rust and deterioration, wash it thoroughly and frequently at least once a month with lukewarm or cold water. If you use your vehicle for off-road driving, you should wash it after each offroad trip. Pay special attention to the remov ...

Kia Cee'd JD Owners Manual: Non-operational conditions of parking assist system
Parking assist system may not operate normally when: 1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.) 2. Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is remo ...