Kia Cee'd: ESP(Electronic Stability Program) System / ESP OFF Switch Repair procedures

Kia Cee'd JD Service Manual / Brake System / ESP(Electronic Stability Program) System / ESP OFF Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad center lower panel. (Refer to Crash Pad - "Crash Pad Center Panel")

3.	Remove the center facia switch assembly (A) after loosening screws.

4.	Check the continuity between the switch terminals as the ESP OFF switch is engaged.

ESP OFF Switch Description and operation

Description • 1st stage The ESP engine control function will stop when the ESP OFF indicator on the cluster turns on by pressing the ESP OFF button for ...

Steering Angle Sensor Description and operation

Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to ...

Other information:

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Kia Cee'd JD Owners Manual: Scheduled maintenance service
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow Maintenance Under Severe Usage Conditions. Repeated driving short distance of less than 8 km (5 miles) in normal tempe ...