Kia Cee'd: Automatic climate control system / Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.
1. Start the engine.
2. Set the mode to the desired position.
To improve the effectiveness of heating
and cooling:
- Heating: 
- Cooling: 
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air or recirculated position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
Automatic heating and air conditioning
The automatic climate control system is
controlled by simply setting the desired
temperature.
Soft mode
Fast mode
You can choose either the soft mode or
fast mode to select the fan speed. ...
Mode selection
The mode selection button controls the direction of the airflow in the
vehicle.
If you push the button once, the corresponding switch will turn on, and if you
push the
button again, the swit ...
Other information:
Kia Cee'd JD Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
...
: Using Seatbelts
WARNING: Depending on where
you secure a child restraint, and
depending on the child restraint design,
you may block access to certain seatbelt
buckle assemblies and LATCH lower
anchors, rendering those features
potentially unusable. To avoid risk of
injury, make sure occupants only use
seat ...
