Kia Cee'd: Fuses / Multi fuse
If the multi fuse is blown, it must be removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right side in the engine compartment.
4. Remove the nuts shown in the picture above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.
✽ NOTICE
If the multi fuse or main fuse is blown, we recommend that you consult an authorized Kia dealer.
Main fuse
Electrical equipments are not working
even though inner panel and engine
compartment fuses are not blown, or
many of these are not working at the
same time, it may has blown the main
fuse( ...
Other information:
Kia Cee'd JD Service Manual: Front Wiper Motor Repair procedures
Removal
1.
Remove the cap (B) and remove the nuts, then remove the wiper arm (A).
Tightening torque :
22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)
2.
If necessary ...
Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Description and operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, the engine may stop because of CKPS signal missing.
This sensor is installed in ladder fra ...
