Kia Cee'd: Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Remove the timing chain cover.
(Refer to Timing System - "Timing Chain Cover")
2.
Remove the pump cover (A).
Tightening torque :
8.8 ~ 13.7N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft)
3.
Remove the inner rotor(A) and outer rotor(B).

4.
Install in the reverse order of removal.
Oil Pump Components and components location
Components   1.  Timing chain cover 2.  Inner rotor 3.  Outer rotor 4.  Pump cover ...

Oil Pressure Switch Repair procedures
Removal and Installation 1. Remove the under cover. 2. Remove the oil drain plug, and drain the oil into a container. ...

Other information:

Kia Cee'd JD Owners Manual: Inside light (5 Door and Wagon)
1. Turn off the engine. 2. Open the tailgate. 3. Remove the service cover using a flatblade screwdriver. 4. Loosen the retaining nuts. 5. Disconnect the power connector. 6. Remove the rear combination light assembly from the body of the vehicle. Tail light or tail and stop light (Bul ...

Kia Cee'd JD Owners Manual: Static bending light
While driving the corner, for your sight and safety, the static bending light turns on automatically. The system will operate automatically as follows: When vehicle speed is under 10km/h and steering wheel angle approximately 80 degrees. When vehicle speed is over 10km/h and ste ...

© 2017-2024 www.kceed.com