Kia Cee'd: Concentric Slave Cylinder Assembly / Repair procedures

Kia Cee'd JD Service Manual / Clutch System / Concentric Slave Cylinder Assembly / Repair procedures

Removal

Remove the transaxle assembly.

G 1.6 MPI (Refer to Manual Transaxle System - " Manual Transaxle")

G 1.4 MPI (Refer to Manual Transaxle System - " Manual Transaxle")

D 1.6 TCI-U2 (Refer to Manual Transaxle System - " Manual Transaxle")

D 1.4 TCI-U2 (Refer to Manual Transaxle System - " Manual Transaxle")

G 1.6 GDI (Refer to Manual Transaxle System - " Manual Transaxle")

G 1.6 T-GDI (Refer to Manual Transaxle System - " Manual Transaxle")

Remove the concentric slave cylinder assembly from the transaxle case by removing bolts (A).

Tightening torque:

19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)

Installation

•	Install the concentric slave cylinder bolts. Not to be bent or twisted, Tighten them in diagonal directions.

•	When it is assembled, it must be free from invasive foreign matters and oil leakage.

1.	Installation is in reverse order of removal.

2.	Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid. (Refer to Concentric Slave Cylinder Assembly - "Adjustment")

Adjustment

Concentric Slave Cylinder Air Bleeding Procedure

1.	After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the plug.

Refill the reservoir tank with the specified fluid.

Use the specified fluid. Avoid mixing different brands of fluid.

Specified fluid: SAE J1703 (DOT 3 or DOT 4)

3.	Pump the clutch pedal about 10 times.

4.	Loosen the air bleed screw (A) at hold down the clutch pedal to allow air to escape from the clutch system. Then tighten the air bleed screw.

5.	Repeat the step 2 ~ 4 until there is no bubble in the fluid.

Components and components location

Component 1. Concentric slave cylinder assembly 2. Manual transaxle ...

Manual Transaxle System

...

Other information:

: Checking the Tire Pressures. Inflating the Tires
Checking the Tire Pressures Safe operation of your vehicle requires that your tires are properly inflated. Remember that a tire can lose up to half of its air pressure without appearing flat. Every day before you drive, check your tires. If one looks lower than the others, use a tire gauge to ...

Kia Cee'd JD Owners Manual: Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided in chapter 7, “Maintenance”. WARNING Driving while distracted can result in a loss of v ...